Xbox 360 Falcon Parts
Choose Category
Parts that work with Xbox 360 Falcon:
Arctic Silver Thermal Paste
Forms a continuous, heat conductive layer between a processor and its heat sink. A new layer of thermal paste keeps your processor from overheating. 3.5 grams
Arctic Silver ArctiClean
Two part cleaner dissolves old thermal paste on heat sinks and processors. One 30 ml bottle of thermal material remover and one 30 ml bottle of thermal surface purifier.
Xbox 360 Red Ring of Death Fix Kit
Fix kit for Xbox 360 consoles with the "Red Ring of Death" (RRoD) failure. Replace, reattach, and reclamp the heat sinks on your Xbox 360. Usually fixes a RRoD Xbox—als...
Xbox 360 Lower Case
Replace the plastic outer casing covering the lower half of the Xbox 360.
Xbox 360 HDD
Replace the hard drive with its plastic and metal hard drive enclosure that snaps onto the the Xbox 360 console.
Xbox 360 X Clamps
Replace the two X clamps for securing the CPU and GPU heat sinks.
Xbox 360 Chassis
Replace the stamped steel chassis that provides structural support inside the Xbox 360.
Xbox 360 RF Module
This small circuit board houses the electronic power button and LED status lights.
Xbox 360 Motherboard Screw Set
This set of screws secures the motherboard to the chassis.
Xbox 360 Bottom Vent
This gray plastic perforated vent covers the bottom face of the Xbox 360.
Device Info
The Xbox 360 Falcon was the third revision of the Xbox 360. This revision featured a simplified and updated motherboard an improved CPU cooler. The console also featured a smaller power supply and a new power supply connector.