How to fix inductor?
The inductor still seems to be on the board, should I remove it and use a circuit writer to bridge the gap?
Also, does anybody have a picture of the blue inductor on the 4S as I dont want to do the wrong one!
Thanks
View:
Passed VotesAnyone with over 20 reputation can flag problematic comments and posts.
Show details
Rep: 31
Posted:
The inductor still seems to be on the board, should I remove it and use a circuit writer to bridge the gap?
Also, does anybody have a picture of the blue inductor on the 4S as I dont want to do the wrong one!
Thanks
Rep: 782.1k
Posted:
Tristan, what you are looking at is schematic number L47_RF a 5.6NH+/-0.2NH-470MA inductor manufactured by MURATA. Part number is LQW04AN5N6D00D available right here with part number 81-LQW04AN5N6D00D The physical dimension are 0.8mm long, 0.4mm wide and 0.4mm high. This is not a part that should be repaired with a soldering gun. This needs either a hot air soldering station or a very fine soldering tip, a steady hand and good magnification source. It may just be easier to use a circuit writer to just close the circuit from one point to the next. Hope this helps, good luck.
Oops! I'd like to change my mind.
Expand / Collapse
Pass
Up
Fail
Down
Open Help
Page 1 of 1