Fix Your Stuff Community Store

uAttend bn6000 Fingerprint Replacement

Introduction

The fingerprint scanner reads the fingerprint of the employee being scanned. This guide will show you how to remove and replace the fingerprint scanner. Be careful not to damage the glass screen scanner.

What you need

  1. uAttend bn6000 Fingerprint Replacement, Disassembly: step 1, image 1 of 1

    • Make sure to unplug the device before starting.

    • Flip the device over.

    • Remove the four 10mm PH #2 screws by rotating the screwdriver counterclockwise, removing the screw from the housing completely.

  2. uAttend bn6000 Fingerprint Replacement: step 2, image 1 of 1

    • Separate the two cover pieces carefully by pulling apart the two cover pieces away from each other.

  4. uAttend bn6000 Fingerprint Replacement, Fingerprint: step 3, image 1 of 3 uAttend bn6000 Fingerprint Replacement, Fingerprint: step 3, image 2 of 3 uAttend bn6000 Fingerprint Replacement, Fingerprint: step 3, image 3 of 3

    • Remove the two 7mm PH #1 screws from the fingerprint scanner mounting tab by rotating the screw driver counter clockwise, removing the screw from the housing completely.

    • Remove the fingerprint scanner assembly from the unit by lifting the scanner up and away from the unit housing.

  5. uAttend bn6000 Fingerprint Replacement: step 4, image 1 of 3 uAttend bn6000 Fingerprint Replacement: step 4, image 2 of 3 uAttend bn6000 Fingerprint Replacement: step 4, image 3 of 3

    • Disconnect the ZIF connector, by using your fingernail to lift up on the small locking flap. Then pull the ribbon up and away, out of the connector.

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 3

All Time: 517