Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

English
Spanish

Translating step 4

Step 4
If you are trying to remove the belt, you may skip to the next step.
  • If you are trying to remove the belt, you may skip to the next step.

  • Remove the 7.5mm Torx #20 screw in front of the motor.

  • The motor is the gray block on the right side of the floor nozzle (when the nozzle faces towards you).

Insert translation here

Insert translation here

Insert translation here

Your contributions are licensed under the open source Creative Commons license.