Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

English
Italian

Translating step 8

Step 8
Lay a hot iOpener along the upper left corner of the iPad, spanning from the opening pick to the front-facing camera. After letting the adhesive soften, insert the blade of your halberd spudger into the iPad above the opening pick. Cut the adhesive along the upper left side of the iPad towards the front-facing camera using the halberd spudger. This may require reheating the edge of the iPad.
  • Lay a hot iOpener along the upper left corner of the iPad, spanning from the opening pick to the front-facing camera.

  • After letting the adhesive soften, insert the blade of your halberd spudger into the iPad above the opening pick.

  • Cut the adhesive along the upper left side of the iPad towards the front-facing camera using the halberd spudger. This may require reheating the edge of the iPad.

Appoggia un iOpener caldo sull'angolo in alto a sinistra dell'iPad, partendo dal plettro ed arrivando alla fotocamera frontale.

Dopo aver lasciato ammorbidire l'adesivo, infila la lama del tuo spudger halberd sopra al plettro.

Taglia l'adesivo lungo il bordo sinistro superiore dell'iPad verso la fotocamera frontale usando lo spudger. Potresti dover riscaldare più volte il bordo dell'iPad.

Your contributions are licensed under the open source Creative Commons license.