Skip to main content

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 4 guides that include this step.

English
Italian

Translating step 2

Step 2
The rear panel is secured to the front case by eight clips permanently attached to the rear panel.  These clips lock onto small tabs machined into the front case.
  • The rear panel is secured to the front case by eight clips permanently attached to the rear panel. These clips lock onto small tabs machined into the front case.

  • To free the tabs, they must be pushed toward the center of the Nano. Note the location of all tabs on the rear panel. When using an iPod opening tool to free the rear panel, be sure to work the tool at the location of these clips.

  • To aid in visualization, the two clips boxed in red are located closest to the headphone jack.

La copertura posteriore è fissata a quella anteriore da otto alette attaccate permanentemente alla copertura posteriore stessa. Queste alette si agganciano a dei piccoli ganci sulla copertura anteriore.

Per liberare i ganci, devono essere spinti verso il centro dell'iPod Nano. Ricordati la posizione di ogni gancio sulla copertura posteriore. Mentre usi uno strumento di apertura per iPod per liberare la copertura posteriore, assicurati di infilarlo dove sono questi ganci.

Per aiutarti nel trovare i ganci, i due cerchiati in rosso sono i più vicini alla presa jack.

Your contributions are licensed under the open source Creative Commons license.