Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

English
Italian

Translating step 3

Step 3
Push the tip of a spudger beneath the rubber adhesive and toward the battery to free it from the surface of the logic board.
  • Push the tip of a spudger beneath the rubber adhesive and toward the battery to free it from the surface of the logic board.

  • Start freeing the adhesive from around one of the outer leads, then free it from the two gaps between leads, and finally push the spudger along the back side of the leads to completely remove it from the logic board/battery leads.

  • The battery leads are delicate, so be careful to not tear them while removing the black adhesive.

Spingi la punta di uno spudger sotto l'adesivo e verso la batteria per separarlo dalla superficie della scheda madre.

Inizia a separare l'adesivo attorno ad uno che cavi esterni, quindi liberalo dai due spazi tra i cavi ed infine spingi lo spudger sul retro dei cavi per rimuoverlo completamente dalla scheda madre/contatti della batteria.

I contatti della batteria sono delicati, quindi stai attento a non strapparli mentre rimuovi l'adesivo nero.

Your contributions are licensed under the open source Creative Commons license.