Skip to main content

Fix Your Stuff

Right to Repair

Store

Notice: You are editing a prerequisite guide. Any changes you make will affect all 15 guides that include this step.

English
Italian

Translating step 1

Step 1
Make sure the battery is disconnected before you disconnect or reconnect the cables in this step. Use the flat end of a spudger or a fingernail to disconnect the two lower display connectors by prying them straight up from their sockets on the logic board. To re-attach press connectors, press down on one end until it clicks into place, then repeat on the other end. Do not press down on the middle. If the connector is even slightly misaligned, the connector can bend, causing permanent damage.
  • Make sure the battery is disconnected before you disconnect or reconnect the cables in this step.

  • Use the flat end of a spudger or a fingernail to disconnect the two lower display connectors by prying them straight up from their sockets on the logic board.

  • To re-attach press connectors, press down on one end until it clicks into place, then repeat on the other end. Do not press down on the middle. If the connector is even slightly misaligned, the connector can bend, causing permanent damage.

  • If you have a blank screen, white lines on the display, or partial or complete lack of touch response after reassembling your phone, try disconnecting and carefully reconnecting both of these cables and make sure they are fully seated.

In questo passo, accertati che la batteria sia scollegata quando disconnetti o riconnetti i cavi.

Usa l'estremità piatta di uno spudger oppure un'unghia per disconnettere i due connettori inferiori del display sollevandoli verso l'alto dai loro zoccolini sulla scheda logica.

Per ricollegare il connettore a pressione, premi una delle estremità finché il clic conferma il corretto posizionamento, poi ripeti l'operazione dall'altra parte. Non premere in mezzo. Se il connettore è anche lievemente fuori allineamento, il connettore può piegarsi, causando un danno permanente.

Se dopo aver rimontato il telefono ti ritrovi con uno schermo bianco, linee bianche sul display oppure se manca, del tutto o in parte, la risposta touch, prova a staccare e riattaccare con cura entrambi questi cavi e assicurati che siano ben bloccati in posizione.

Your contributions are licensed under the open source Creative Commons license.