Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 19 guides that include this step.

English
Japanese

Translating step 3

Step 3
Pull up on the suction cup to create a small gap between the display assembly and the rear case. Insert the flat end of a spudger into the gap. The watertight adhesive holding the display in place is very strong, and creating this initial gap takes a significant amount of force. If you're having a hard time opening a gap, rock the screen up and down to weaken the adhesive until you can fit a spudger inside.
  • Pull up on the suction cup to create a small gap between the display assembly and the rear case.

  • Insert the flat end of a spudger into the gap.

  • The watertight adhesive holding the display in place is very strong, and creating this initial gap takes a significant amount of force. If you're having a hard time opening a gap, rock the screen up and down to weaken the adhesive until you can fit a spudger inside.

ディスプレイアセンブリと背面ケースの間に小さな隙間が出来るように吸盤カップで引き上げます。

スパッジャーの平面側先端を隙間に差し込みます。

ディスプレイを留めている耐水性のある接着剤はとても強力です。最初の隙間を作るためにかなりの努力が必要です。もし隙間を作るのが難しい場合は、スパッジャーを内部に差し込めるほどの隙間ができるまで、吸盤カップを上下に動かし続けてください。

Your contributions are licensed under the open source Creative Commons license.