Menu

Your Settings

Notice: You are editing a prerequisite guide. Any changes you make will affect all 20 guides that include this step.

Back to Guide
English
Spanish
Previous step Next step

Translating step 3

Step 3
Pull up on the suction cup to create a small gap between the display assembly and the rear case. Insert the flat end of a spudger into the gap. The watertight adhesive holding the display in place is very strong, and creating this initial gap takes a significant amount of force. If you're having a hard time opening a gap, rock the screen up and down to weaken the adhesive until you can fit a spudger inside.

  • Pull up on the suction cup to create a small gap between the display assembly and the rear case.

  • Insert the flat end of a spudger into the gap.

  • The watertight adhesive holding the display in place is very strong, and creating this initial gap takes a significant amount of force. If you're having a hard time opening a gap, rock the screen up and down to weaken the adhesive until you can fit a spudger inside.

Tira hacia arriba de la ventosa para crear un pequeño espacio entre el ensamblaje de pantalla y la caja trasera.

Inserta el extremo plano de un spudger en el hueco.

El adhesivo que sostiene la pantalla en su lugar es muy fuerte, y la creación de esta separación inicial requiere una cantidad significativa de fuerza. Si te resulta difícil crear una abertura, oscila la pantalla hacia arriba y abajo para debilitar el pegamento hasta que puedas insertar el spudger.

Your contributions are licensed under the open source Creative Commons license.