Skip to main content

Fix Your Stuff

Right to Repair

Store

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

English
Italian

Translating step 2

Step 2
Remove the two 8.2 mm T6 Torx screws securing the hard drive retaining bracket to the lower case. Use a spudger if the hard drive ribbon cable is firmly glued to the top of the drive. You might have to work slowly in order to not damage it. Lift the hard drive retaining bracket up and out of the computer.
  • Remove the two 8.2 mm T6 Torx screws securing the hard drive retaining bracket to the lower case.

  • Use a spudger if the hard drive ribbon cable is firmly glued to the top of the drive. You might have to work slowly in order to not damage it.

  • Lift the hard drive retaining bracket up and out of the computer.

  • Lift up the hard drive with one hand and use your other hand to disconnect the hard drive cable.

Rimuovere le due viti Torx T6 da 8,2 mm che fissano la staffa di fissaggio del disco rigido al case inferiore.

Usare una spatola si il cavo nastro del disco rigido è fortemente incolloto sulla parte superiore del lettore. Attenzione di lavorare lentamente per evitare di danneggiarlo.

Sollevare la staffa di fissaggio del disco rigido e rimuoverla dal computer.

Sollevare il disco rigido con una mano e utilizzare l'altra per scollegare il relativo cavo.

Your contributions are licensed under the open source Creative Commons license.