Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 2 guides that include this step.

English
German

Translating step 28

Step 28
As you complete the next few steps, prying adhesive securing the logic board in place, always start by testing gently to see if the adhesive is softened. If not, reheat the iOpener and reapply it to the back of the rear case. Carefully insert an opening pick under the logic board, between the front-facing camera and the battery. Be sure to insert the pick over the the antenna cable that runs along the length of the battery.
  • As you complete the next few steps, prying adhesive securing the logic board in place, always start by testing gently to see if the adhesive is softened. If not, reheat the iOpener and reapply it to the back of the rear case.

  • Carefully insert an opening pick under the logic board, between the front-facing camera and the battery.

  • Be sure to insert the pick over the the antenna cable that runs along the length of the battery.

  • Slide the guitar pick toward the front-facing camera connector, and stop at the bend in the logic board.

In den nächsten Schritten wirst du den Kleber lösen, mit dem das Logic Board befestigt ist. Heble am Anfang immer ganz vorsichtig und prüfe, ob der Kleber schon weich ist. Wenn dass nicht der Fall ist, dann erwärme den iOpener erneut und lege ihn auf die Rückseite des Rückgehäuses auf.

Setze ganz behutsam ein Plektrum zwischen Frontkamera und Akku unter das Logic Board ein.

Achte darauf, dass sich das Plektrum über dem Antennenkabel befindet. Es verläuft auf ganzer Länge über dem Akku entlang.

Schiebe das Plektrum zum Stecker der Frontkamera hin. Halte an der Biegung des Logic Boards an.

Your contributions are licensed under the open source Creative Commons license.