Fix Your Stuff

Right to Repair

Store

Notice: You are editing a prerequisite guide. Any changes you make will affect all 12 guides that include this step.

Back to Guide
English
Italian
Previous step Next step

Translating step 14

Step 14
Be careful not to touch any solder joints on the back of the power supply. Capacitors may be charged enough to give you a dangerous shock. Remove the following four screws:

  • Be careful not to touch any solder joints on the back of the power supply. Capacitors may be charged enough to give you a dangerous shock.

  • Remove the following four screws:

  • One 9.3 mm T10 coarse-threaded screw

  • One 25 mm T10 coarse-threaded screw

  • Two 22 mm fine-threaded screws

  • Pull the upper right and lower left corners of the power supply away from the rear case to dislodge the mounting posts attached to the power supply's corners.

Insert translation here

Insert translation here

Insert translation here

Insert translation here

Insert translation here

Insert translation here

Your contributions are licensed under the open source Creative Commons license.