Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 28 guides that include this step.

English
German

Translating step 6

Step 6
Disconnect the LCD thermal sensor cable connector from its socket on the logic board. If your fan is spinning full speed after completion, check this connection or the hard drive's thermal sensor cable.
  • Disconnect the LCD thermal sensor cable connector from its socket on the logic board.

  • If your fan is spinning full speed after completion, check this connection or the hard drive's thermal sensor cable.

Löse den Verbinder des Thermosensorkabels zum LCD aus seinem Sockel auf dem Logic Board.

Wenn der Ventilator nach dem Zusammenbau auf Höchstdrehzahl arbeitet, musst du die Orientierung an diesem Verbinder oder am Thermosensorkabel der Festplatte prüfen.

Your contributions are licensed under the open source Creative Commons license.