Skip to main content

MacBook Pro 15" Unibody Early 2011光学ドライブの交換

Notice: You are editing a prerequisite guide. Any changes you make will affect all 15 guides that include this step.

Translating step 4

English
Japanese
Step 4
MacBook Pro 15" Unibody Early 2011 Optical Drive Replacement: step 0, image 1 of 2 MacBook Pro 15" Unibody Early 2011 Optical Drive Replacement: step 0, image 2 of 2
  • Remove following two screws:

  • Take care, as these screws are unusually easy to strip. Apply firm pressure while unscrewing. Read comments before proceeding.

  • One 8.6 mm Phillips screw

  • One 3.9 mm Phillips screw

  • Carefully rotate the AirPort/Bluetooth board housing (with AirPort/Antenna cables still attached) out of the lower case.

次の2つのネジを外します。

これらのネジは通常とは違って滑りやすいためご注意ください。ネジを外す際にはしっかりと下に押し込みます。作業を始める前に下のコメントを参照してください(英語)。

8.6 mmプラスネジー1本

3.9 mm プラスネジー1本

下部ケースからAirPort/Bluetooth ボードハウジングを手に取り、(AirPort/Bluetooth ケーブルがまだ装着されたまま)回転させます。

Your contributions are licensed under the open source Creative Commons license.