Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 2 guides that include this step.

English
Spanish

Translating step 5

Step 5
Push with your fingers on the rear panel behind the putty knife to minimize bending. Slowly flex the putty knife, as shown in the picture, to ensure that most of the metal tabs on this side of the iPod are disengaged.
  • Push with your fingers on the rear panel behind the putty knife to minimize bending. Slowly flex the putty knife, as shown in the picture, to ensure that most of the metal tabs on this side of the iPod are disengaged.

  • The theory behind this method is, rather than attempting to not bend the rear panel at all, to bend it in a favorable manner that allows you to easily restore it later. Therefore, any bend in the sides of the rear panel should be drawing the lip of the rear panel away from the iPod, rather than pushing out on the curved surface. This method also disengages as many of the side clips as possible.

Empuja con tus dedos sobre el panel trasero detrás de la espátula, para minimizar el doblamiento. Lentamente, dobla la espátula (tal y como se muestra en la imagen) para asegurarte de que la mayoría de los enganches de metal de este lado del iPod se suelten.

La teoría tras este método no se basa en no doblar el panel trasero, sino en doblarlo de manera que pueda recuperar fácilmente su forma. Por lo tanto, cualquier doblez del panel trasero debería alejarlo del iPod, y no empujarlo hacia la superficie curvada. Este método, además, también soltará la mayor cantidad de enganches laterales posible.

Your contributions are licensed under the open source Creative Commons license.