Skip to main content

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 22 guides that include this step.

English
German

Translating step 4

Step 4
Disconnect the digitizer cable by prying it straight up from its socket on the logic board. When reconnecting the digitizer cable, do not press the center of the connector. Press one end of the connector, then press the opposite end. Pressing in the center of the connector can bend the component and cause digitizer damage.
  • Disconnect the digitizer cable by prying it straight up from its socket on the logic board.

  • When reconnecting the digitizer cable, do not press the center of the connector. Press one end of the connector, then press the opposite end. Pressing in the center of the connector can bend the component and cause digitizer damage.

Löse mit dem flachen Ende eines Spudgers oder einem Fingernagel den Stecker des Digitizerkabels vom Logic Board, indem du es gerade nach oben hebelst.

Wenn du das Kabel wieder verbindest drücke nicht in der Mitte des Steckers. Drücke erst an einem Ende, dann am gegenüberliegenden. Beim Drücken in der Mitte des Kabels kann der Stecker verbiegen und beschädigt werden.

[* black] Use the flat end of a spudger, or a fingernail, to disconnectDisconnect the digitizer cable by prying it straight up from its socket on the logic board.
[* black] Use the flat end of a spudger, or a fingernail, to disconnectDisconnect the digitizer cable by prying it straight up from its socket on the logic board.
[* icon_caution] When reconnecting the digitizer cable, '''do not press the center of the connector'''. Press one end of the connector, then press the opposite end. Pressing in the center of the connector can bend the component and cause digitizer damage.

Your contributions are licensed under the open source Creative Commons license.