Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 2 guides that include this step.

English
Japanese

Translating step 12

Step 12
Use the flat end of the plastic spudger to rotate the black plastic locking tab towards the ribbon cable. Insert the pointed end of the plastic spudger into a small hole on the side of the ribbon cable and pull the ribbon cable out of its housing. Use the flat end of the plastic spudger to pry the ribbon cable connector from the motherboard.
  • Use the flat end of the plastic spudger to rotate the black plastic locking tab towards the ribbon cable.

  • Insert the pointed end of the plastic spudger into a small hole on the side of the ribbon cable and pull the ribbon cable out of its housing.

  • Use the flat end of the plastic spudger to pry the ribbon cable connector from the motherboard.

  • Both ribbon cables should be removed after this step.

Insert translation here

Insert translation here

Insert translation here

Insert translation here

Your contributions are licensed under the open source Creative Commons license.