Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 23 guides that include this step.

English
Japanese

Translating step 4

Step 4
Disconnect the digitizer cable by prying it straight up from its socket on the logic board. When reconnecting the digitizer cable, do not press the center of the connector. Press one end of the connector, then press the opposite end. Pressing in the center of the connector can bend the component and cause digitizer damage.
  • Disconnect the digitizer cable by prying it straight up from its socket on the logic board.

  • When reconnecting the digitizer cable, do not press the center of the connector. Press one end of the connector, then press the opposite end. Pressing in the center of the connector can bend the component and cause digitizer damage.

基板上ソケットからデジタイザーケーブルをまっすぐ上げて、接続を外します。

デジタイザケーブルを再接続する際は、コネクターの中央を押さないでください。コネクターの片一方を押し込んでから、反対側を押します。コネクターの中央を押すとコンポーネントが曲がり、デジタイザーにダメージを与えてしまいます。

Your contributions are licensed under the open source Creative Commons license.