Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 23 guides that include this step.

English
Italian

Translating step 4

Step 4
Disconnect the digitizer cable by prying it straight up from its socket on the logic board. When reconnecting the digitizer cable, do not press the center of the connector. Press one end of the connector, then press the opposite end. Pressing in the center of the connector can bend the component and cause digitizer damage.
  • Disconnect the digitizer cable by prying it straight up from its socket on the logic board.

  • When reconnecting the digitizer cable, do not press the center of the connector. Press one end of the connector, then press the opposite end. Pressing in the center of the connector can bend the component and cause digitizer damage.

Scollega il cavo del digitizer facendo leva verso l'alto dal suo zoccolo sulla scheda logica.

Quando devi riattaccare il cavo del digitizer, non premere nel centro del connettore. Premi da un lato e poi dall'altro. Premendo nel centro del connettore si può piegare questo elemento e causare danni al digitizer.

Your contributions are licensed under the open source Creative Commons license.