Skip to main content

Fix Your Stuff

Right to Repair

Store

English
Japanese

Translating step 3

Step 3
In the next three steps, take care to pry up only on the cable connectors, and not on their sockets on the logic board. Use the flat end of a spudger to disconnect the front-facing camera and sensor cable connector. Use the flat end of a spudger to disconnect the front-facing camera and sensor cable connector.
  • In the next three steps, take care to pry up only on the cable connectors, and not on their sockets on the logic board.

  • Use the flat end of a spudger to disconnect the front-facing camera and sensor cable connector.

次の3つの手順ではケーブルコネクターのみこじ開けるようご注意ください。ソケットやロジックボードには接触しないでください。

スパッジャーの平面側先端を使って正面カメラとセンサーケーブルコネクターの接続を外します。

Your contributions are licensed under the open source Creative Commons license.