Skip to main content

Fix Your Stuff

Right to Repair

Store

English
Chinese

Translating step 1

Step 1
While holding the front panel open at about a 90º angle, remove the following screws securing the front panel assembly cable bracket:
  • While holding the front panel open at about a 90º angle, remove the following screws securing the front panel assembly cable bracket:

  • Three 1.3 mm Phillips #00 screws

  • One 3.0 mm Phillips #00 screw

  • Don't lose track of this screw! It's very important that the one 3.0 mm screw goes in the top-right corner of the plate. Anywhere else may cause damage to the logic board.

竖起前置面板与平面约成90°角,同时取下固定前置面板屏蔽罩的螺丝:

3颗1.3mm飞利浦00号螺丝

1颗3.0mm飞利浦00号螺丝

不要拧错螺丝的位置。这非常重要:3.0mm的螺丝在屏蔽罩的右上角。任何地方拧错了都可能会损坏主板。

Your contributions are licensed under the open source Creative Commons license.