Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 2 guides that include this step.

English
German

Translating step 2

Step 2
Use the Pentalobe screwdriver to remove the two 3.6 mm Pentalobe screws near the dock connector. Use the Pentalobe screwdriver to remove the two 3.6 mm Pentalobe screws near the dock connector.
  • Use the Pentalobe screwdriver to remove the two 3.6 mm Pentalobe screws near the dock connector.

Löse mit dem Pentalobe-Schraubendreher die beiden 3,6 mm Pentalobe-Schrauben neben dem Dock Connector.

Der P2 Pentalobe-Schraubendreher sollte nicht zu oft verwendet werden, da er die Schrauben sehr leicht durchdreht.

[* red] Use the Pentalobe screwdriver to remove the two 3.6 mm Pentalobe screws near the dock connector.
[* icon_caution] The 5-Point Pentalobe screwdriver should only be used a limited number of times because it has the potential to strip the screws.

Your contributions are licensed under the open source Creative Commons license.