Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

English
French

Translating step 5

Step 5
Working from the edge opposite the battery connectors, insert a spudger between the battery and the plastic frame and pry up on the battery. It is attached to the casing with an adhesive, but should slowly come free.
  • Working from the edge opposite the battery connectors, insert a spudger between the battery and the plastic frame and pry up on the battery. It is attached to the casing with an adhesive, but should slowly come free.

  • Leave the battery resting slightly out of its housing, but be sure not to put too much pressure on the battery wires as the solder joints break easily.

En commençant par le côté opposé des connecteurs de batterie, insérez une spatule entre la batterie et le cadre en plastique et faites levier. La batterie est attachée au boîtier par un adhésif, mais elle devrait se détacher lentement.

Laissez la batterie posée légèrement en dehors de son emplacement mais veillez à ne pas mettre trop de pression sur les fils de la batterie, car les joints soudés se brisent facilement.

Your contributions are licensed under the open source Creative Commons license.