Skip to main content

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 5 guides that include this step.

English
French

Translating step 5

Step 5
Place the driver flat on a table before completely separating the two halves of the housing so components of the drill don't fall out during opening.
  • Place the driver flat on a table before completely separating the two halves of the housing so components of the drill don't fall out during opening.

  • Pry apart the two halves of the housing at the back side of the driver using the metal spudger.

  • The housing is easier to remove if you pry from multiple sides.

Placez la perceuse à plat sur une table avant de séparer complètement les deux moitiés du boîtier afin que les composants ne tombent pas lors de l'ouverture.

Séparez les deux moitiés du boîtier à l'arrière du conducteur à l'aide du spudger métallique.

Le logement est plus facile à retirer si vous faites levier sur plusieurs côtés.

-[* icon_caution] Place the driver flat on a table before completely separating the two halves of the housing so components don't fall out during opening.
-[* black] Pry apart the two halves of the housing at the back side of the driver using the metal spudger .
+[* icon_caution] Place the driver flat on a table before completely separating the two halves of the housing so components of the drill don't fall out during opening.
+[* black] Pry apart the two halves of the housing at the back side of the driver using the metal spudger.
[* icon_note] The housing is easier to remove if you pry from multiple sides.

Your contributions are licensed under the open source Creative Commons license.