Skip to main content

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

English
German

Translating step 2

Step 2
Squeeze the heat sink thermal sensor cable between your thumb and the tip of a spudger.
  • Squeeze the heat sink thermal sensor cable between your thumb and the tip of a spudger.

  • Lift the spudger upward to lift the thermal sensor connector out of its socket on the logic board.

  • The early 2011 model may not have a thermal sensor connector.

Klemme das Kabel des Wärmesensors am Kühlkörper zwischen deinem Daumen und der Spudgerspitze ein.

Hebe den Spudger hoch und hebe dabei den Stecker am Kabel des Wärmesensors aus seinem Anschluss auf dem Logic Board heraus.

Es kann sein, dass im Modell von Anfang 2011 kein Stecker am Wärmesensorkabel verbaut ist.

Your contributions are licensed under the open source Creative Commons license.