Skip to main content

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 7 guides that include this step.

English
German

Translating step 9

Step 9
Remove the following four screws: Two 3.5 mm Phillips screws These may be T5 Torx screws in the Early 2011 model
  • Remove the following four screws:

  • Two 3.5 mm Phillips screws

  • These may be T5 Torx screws in the Early 2011 model

  • Two 1.6 mm Phillips screws

  • Remove both connector shields from the logic board.

Entferne folgende vier Schrauben:

Zwei 3,5 mm Kreuzschlitzchrauben

Beim Modell von Anfang 2011 können das auch Torx T5 Schrauben sein.

Zwei 1,6 mm Kreuzschlitzschrauben

Entferne die beiden Steckerabschirmungen vom Logic Board.

Your contributions are licensed under the open source Creative Commons license.