Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 3 guides that include this step.

English
Italian

Translating step 3

Step 3
To reinstall the X clamp, first start by attaching two corners to the posts on the heat sink.
  • To reinstall the X clamp, first start by attaching two corners to the posts on the heat sink.

  • While holding the third arm of the X clamp down against the post attached to the heat sink, use a small flathead screwdriver to pry the X clamp away from the heat sink post.

  • As you pry, press down on the arm of the X clamp until you "walk" it down into the retaining groove cut into the post attached to the heat sink.

  • Repeat this process for the fourth arm of the X clamp.

Per reinstallare la X clamp inizia bloccando 2 angoli ai supporti del dissipatore.

Mentre tieni il terzo braccio della X clamp contro il rispettivo supporto del dissipatore, fai leva con un piccolo cacciavite piatto sulla X clamp dal supporto.

Mentre fai leva, spingi verso il basso sul braccio della X clamp per "guidarla" nella scanalatura apposita nel supporto di bloccaggio del dissipatore.

Ripeti questa procedura per il quarto braccio della X clamp.

Your contributions are licensed under the open source Creative Commons license.