Skip to main content

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 18 guides that include this step.

English
French

Translating step 9

Step 9
Remove the following Phillips screws securing the front panel assembly cable bracket:
  • Remove the following Phillips screws securing the front panel assembly cable bracket:

  • Three 1.2 mm screws

  • One 1.5 mm screw

  • One 2.9 mm screw

  • Do not attempt to insert longer screws into the red marked screw holes. Doing so may result in irreparable damage to the logic board.

Tout en tenant l'écran ouvert à un angle de 90°, enlevez les vis suivantes qui maintiennent le cache des connecteurs de l'écran :

Trois vis cruciformes Phillips #00 de 1,2mm

Une vis cruciforme Phillips #00 de 1,5mm

Une vis cruciforme Phillips #00 de 2,9mm

[* black] While holding the front panel open at about a 90º angle, removeRemove the following Phillips screws securing the front panel assembly cable bracket:
[* red] Three 1.2 mm Phillips #00 screws
[* orange] One 1.5 mm Phillips #00 screw
[* yellow] One 2.9 mm Phillips #00 screw
[* icon_caution] '''Do not attempt to insert longer screws into the red marked screw holes. Doing so may result in irreparable damage to the logic board.'''
[* black] While holding the front panel open at about a 90º angle, removeRemove the following Phillips screws securing the front panel assembly cable bracket:
[* red] Three 1.2 mm Phillips #00 screws
[* orange] One 1.5 mm Phillips #00 screw
[* yellow] One 2.9 mm Phillips #00 screw
[* icon_caution] '''Do not attempt to insert longer screws into the red marked screw holes. Doing so may result in irreparable damage to the logic board.'''

Your contributions are licensed under the open source Creative Commons license.