Skip to main content

Fix Your Stuff

Right to Repair

Store

Notice: You are editing a prerequisite guide. Any changes you make will affect all 25 guides that include this step.

English
French

Translating step 3

Step 3
Remove the two 7.2 mm T10 Torx screws securing the power supply to the rear enclosure.
  • Remove the two 7.2 mm T10 Torx screws securing the power supply to the rear enclosure.

  • In newer model iMacs these are 7.2 mm T8 Torx screws.

  • During reassembly, be careful not to trap the power button wire behind the board.

Retirez les deux vis T10 7,2 mm par lesquelles la carte d'alimentation est fixée au boîtier arrière.

[* red] Remove the two 7.2 mm T10 Torx screws securing the power supply to the rear enclosure.
[* icon_note] In newer model iMacs these are 7.2 mm T8 Torx screws.
[* icon_reminder] During reassembly, be careful not to trap the power button wire behind the board.
[* red] Remove the two 7.2 mm T10 Torx screws securing the power supply to the rear enclosure.
[* icon_note] In newer model iMacs these are 7.2 mm T8 Torx screws.
[* icon_reminder] During reassembly, be careful not to trap the power button wire behind the board.

Your contributions are licensed under the open source Creative Commons license.