Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

English
Italian

Translating step 8

Step 8
The screws on the heat sink are held in place by screws and stoppers; they will unscrew, but will not come out of the heat sink. Be careful not to loosen them too much or you may damage the bracket on the back of the CPU. Using a Phillips #1 screw driver unscrew the four screws on the heat sink.
  • The screws on the heat sink are held in place by screws and stoppers; they will unscrew, but will not come out of the heat sink. Be careful not to loosen them too much or you may damage the bracket on the back of the CPU.

  • Using a Phillips #1 screw driver unscrew the four screws on the heat sink.

  • When tightening the screws during reassembly, tighten them in a cross pattern (start by tightening the upper left screw, then the bottom right screw, then the top right screw, and finally the bottom left screw)

  • Lift the bracket up from the motherboard.

Insert translation here

Insert translation here

Insert translation here

Insert translation here

Your contributions are licensed under the open source Creative Commons license.