Skip to main content

Fix Your Stuff

Right to Repair

Store

Notice: You are editing a prerequisite guide. Any changes you make will affect all 52 guides that include this step.

English
Spanish

Translating step 25

Step 25
Be very careful with this step. Take your time and ensure the adhesive is hot and soft, and that you've been through all of the adhesive with an opening pick. Don't be afraid to stop and reheat. On the side of the iPad opposite the volume controls, you should have a pick lodged into each corner. Twist the picks to lift the glass slightly, separating the last of the adhesive along the display cable edge.
  • Be very careful with this step. Take your time and ensure the adhesive is hot and soft, and that you've been through all of the adhesive with an opening pick. Don't be afraid to stop and reheat.

  • On the side of the iPad opposite the volume controls, you should have a pick lodged into each corner. Twist the picks to lift the glass slightly, separating the last of the adhesive along the display cable edge.

  • If you encounter a significant amount of resistance, leave the picks in place, reheat, and reapply the iOpener to the problem areas.

Ten mucho cuidado con este paso. Tómate tu tiempo y asegúrate de que el adhesivo esté caliente y suave, y que haya pasado por todo el adhesivo con una púa de apertura. No tengas miedo de detenerte y recalentar.

En el lado del iPad opuesto a los controles de volumen, debe tener una púa alojada en cada esquina. Gira las púas para levantar ligeramente el vidrio, separando el último adhesivo a lo largo del borde del cable de la pantalla.

Si encuentras una cantidad significativa de resistencia, deja las púas en su lugar, vuelve a calentar y vuelve a aplicar el iOpener en las áreas problemáticas.

Your contributions are licensed under the open source Creative Commons license.