Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 71 guides that include this step.

English
German

Translating step 4

Step 4
Carefully place a suction cup halfway up the heated side. Be sure the cup is completely flat on the screen to get a tight seal. While holding the iPad down with one hand, pull up on the suction cup to slightly separate the front panel glass from from the rear case.
  • Carefully place a suction cup halfway up the heated side.

  • Be sure the cup is completely flat on the screen to get a tight seal.

  • While holding the iPad down with one hand, pull up on the suction cup to slightly separate the front panel glass from from the rear case.

  • If your iPad's screen is badly cracked, covering it with a smooth layer of clear packing tape may help the suction cup adhere. Alternatively, use a strong piece of tape (such as duct tape) and fold it into a handle.

Befestige einen Saugheber auf der linken Seite in der Mitte des iPads.

Drücke den Saugnapf flach auf den Touch Screen.

Halte das iPad mit der einen Hand fest und hebe mit der anderen vorsichtig den Touch Screen vom Gehäuse.

Wenn das Display deines iPads sehr zersplittert ist, kann es hilfreich sein, es mit durchsichtigem Klebeband abzukleben, damit der Saugheber hält. Sonst kannst du auch ein Stück starkes Paketklebeband so falten, dass es einen Griff bildet.

Your contributions are licensed under the open source Creative Commons license.