Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 8 guides that include this step.

English
Spanish

Translating step 2

Step 2
There should be no cables connected to the top of the logic board at this point.
  • There should be no cables connected to the top of the logic board at this point.

  • Remove the following 12 Phillips screws from the logic board:

  • Six 4 mm around the edges of the logic board.

  • Two 5 mm securing the right speaker to the logic board (move the speaker off of the logic board).

  • Three 6 mm with wavy washers in the upper, left corner of the logic board.

  • One 4 mm underneath a black bumper in the back right corner of the logic board.

  • One 4 mm screw may not be present on some logic boards.

Insert translation here

Insert translation here

Insert translation here

Insert translation here

Insert translation here

Insert translation here

Insert translation here

Your contributions are licensed under the open source Creative Commons license.