Skip to main content

Fix Your Stuff

Right to Repair

Store

Notice: You are editing a prerequisite guide. Any changes you make will affect all 4 guides that include this step.

English
Japanese

Translating step 9

Step 9
Lift and remove the battery from the iPhone.
  • Lift and remove the battery from the iPhone.

  • If there's any alcohol solution remaining in the phone, carefully wipe it off or allow it to air dry before installing your new battery.

  • There should be no resistance. If the battery remains stuck, reheat the iOpener and pry again.

  • If your replacement battery came in a plastic sleeve, remove it before installation by pulling it away from the the ribbon cable.

  • Before you adhere the replacement battery, temporarily reconnect the battery connector to the motherboard socket. This ensures that the battery is properly aligned in its recess.

  • Adhere the battery, disconnect it, and continue reassembling your device.

  • If your new battery doesn’t have adhesive preinstalled, refer to this guide to replace the adhesive strips.

  • Perform a hard reset after reassembly. This can prevent several issues and simplify troubleshooting.

iPhoneからバッテリーを持ち上げて取り出します。

バッテリーは簡単に取り出せるはずです。接着剤がバッテリーに残っている場合は、iOpener を使って再度温めてから作業を再開してください。

交換用のバッテリーにプラスチックのカバーがついている場合は、装着前にリボンケーブルからカバーを引っ張り、外してください。

交換用のバッテリーにプレインストールされた接着剤が付いていない場合は、この手順を参照して、バッテリーの接着ストリップの交換を行ってください。

再装着後はハードリセットを行ってください。この作業は幾つかの問題を防ぎ、トラブルシューティングを簡単にしてくれます。

[* black] Lift and remove the battery from the iPhone.
[* icon_reminder] If there's any alcohol solution remaining in the phone, carefully wipe it off or allow it to air dry before installing your new battery.
[* icon_caution] There should be no resistance. If the battery remains stuck, reheat the iOpener and pry again.
[* icon_note] If your replacement battery came in a plastic sleeve, remove it before installation by pulling it away from the the ribbon cable.
[* icon_reminder] Before you adhere the replacement battery, temporarily reconnect the battery connector to the motherboard socket. This ensures that the battery is properly aligned in its recess.
[* black] Adhere the battery, disconnect it, and continue reassembling your device.
[* icon_reminder] If your new battery doesn’t have adhesive preinstalled, refer to [guide|107792|this guide] to replace the adhesive strips.
[* icon_reminder] Perform a [guide|44497|hard reset] after reassembly. This can prevent several issues and simplify troubleshooting.

Your contributions are licensed under the open source Creative Commons license.