Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 4 guides that include this step.

English
Japanese

Translating step 3

Step 3
Set the assembly down on a flat surface to access the connectors on the IO board. Use the tip of a spudger to flip the retaining flap on the IO shield ribbon cable ZIF connector. Disconnect the IO shield ribbon cable.
  • Set the assembly down on a flat surface to access the connectors on the IO board.

  • Use the tip of a spudger to flip the retaining flap on the IO shield ribbon cable ZIF connector.

  • Disconnect the IO shield ribbon cable.

アセンブリを平面上に置き、IOボード上のコネクタにアクセスします。

スパッジャーの先端を使って、IOシールドリボンケーブルのZIFコネクタ上の固定フラップを跳ね上げます。

IOシールドリボンケーブルの接続を外します。

Your contributions are licensed under the open source Creative Commons license.