Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 4 guides that include this step.

English
Spanish

Translating step 3

Step 3
Set the assembly down on a flat surface to access the connectors on the IO board. Use the tip of a spudger to flip the retaining flap on the IO shield ribbon cable ZIF connector. Disconnect the IO shield ribbon cable.
  • Set the assembly down on a flat surface to access the connectors on the IO board.

  • Use the tip of a spudger to flip the retaining flap on the IO shield ribbon cable ZIF connector.

  • Disconnect the IO shield ribbon cable.

Coloxa el conjunto en una superficie plana para acceder a los conectores de la placa E/S.

Utiliza la punta de un spudger para voltear la solapa de retención del conector ZIF del cable de la cinta del escudo E/S.

Desconecta el cable plano del escudo E/S.

Your contributions are licensed under the open source Creative Commons license.