Skip to main content

Fix Your Stuff

Right to Repair

Parts & Tools

Notice: You are editing a prerequisite guide. Any changes you make will affect all 32 guides that include this step.

English
Japanese

Translating step 11

Step 11
During reassembly, use the flat end of a spudger to snap the front portion of the Touch ID cable bracket down over the cable connector. If the bracket does not snap down flush, you may need to remove the bracket and slide it over the cable connector again for a better fit.
  • During reassembly, use the flat end of a spudger to snap the front portion of the Touch ID cable bracket down over the cable connector.

  • If the bracket does not snap down flush, you may need to remove the bracket and slide it over the cable connector again for a better fit.

スパッジャーの平面側先端を使って、Touch IDケーブルブラケットの正面端をケーブルコネクター側にパチンと折ります。

ブラケットが折りたためない場合は、ブラケットを取り出してケーブルコネクター上に正しく装着するように再度スライドしてください。

[* black] Useicon_reminder] During reassembly, use the flat end of a spudger to snap the front portion of the Touch ID cable bracket down over the cable connector.
[* black] Useicon_reminder] During reassembly, use the flat end of a spudger to snap the front portion of the Touch ID cable bracket down over the cable connector.
[* icon_note] If the bracket does not snap down flush, you may need to remove the bracket and slide it over the cable connector again for a better fit.

Your contributions are licensed under the open source Creative Commons license.