Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 32 guides that include this step.

English
Italian

Translating step 11

Step 11
Use the flat end of a spudger to snap the front portion of the Touch ID cable bracket down over the cable connector. If the bracket does not snap down flush, you may need to remove the bracket and slide it over the cable connector again for a better fit.
  • Use the flat end of a spudger to snap the front portion of the Touch ID cable bracket down over the cable connector.

  • If the bracket does not snap down flush, you may need to remove the bracket and slide it over the cable connector again for a better fit.

Usa l'estremità piatta di uno spudger per appiattire sopra il connettore del cavo la parte anteriore della staffa del cavo del Touch ID.

Se la staffa non si dispone a filo, potrebbe essere necessario rimuovere la staffa e farla scorrere di nuovo al di sopra del connettore del cavo per un miglior posizionamento.

Your contributions are licensed under the open source Creative Commons license.