Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 32 guides that include this step.

English
German

Translating step 11

Step 11
Use the flat end of a spudger to snap the front portion of the Touch ID cable bracket down over the cable connector. If the bracket does not snap down flush, you may need to remove the bracket and slide it over the cable connector again for a better fit.
  • Use the flat end of a spudger to snap the front portion of the Touch ID cable bracket down over the cable connector.

  • If the bracket does not snap down flush, you may need to remove the bracket and slide it over the cable connector again for a better fit.

Drücke die Vorderseite der Touch ID Abdeckung mit dem flachen Ende eines Spudgers nach unten über den Anschluss.

Wenn sich die Abdeckung nicht bündig abschließen lässt, musst du sie vielleicht entfernen und erneut über den Anschluss schieben.

Your contributions are licensed under the open source Creative Commons license.