Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 41 guides that include this step.

English
Spanish

Translating step 1

Step 1
In this step you will disconnect the battery to help avoid shorting out any components during service. Use the flat end of a spudger to pry both short sides of the battery connector upward to disconnect it from its socket on the logic board.
  • In this step you will disconnect the battery to help avoid shorting out any components during service.

  • Use the flat end of a spudger to pry both short sides of the battery connector upward to disconnect it from its socket on the logic board.

  • Bend the battery cable slightly away from the logic board so the connector will not accidentally bend back and make contact with its socket.

En este paso, desconectarás la batería para evitar cortocircuitos durante el servicio.

Usa el extremo plano de un spudger para levantar ambos lados cortos del conector de la batería hacia arriba para desconectarlo de su zócalo en la placa lógica.

Dobla el cable de la batería un poco lejos de la placa lógica para que el conector no se doble hacia atrás accidentalmente y haga contacto con su zócalo.

Your contributions are licensed under the open source Creative Commons license.