Fix Your Stuff

Right to Repair

Parts & Tools

Notice: You are editing a prerequisite guide. Any changes you make will affect all 15 guides that include this step.

Back to Guide
English
Japanese
Previous step Next step

Translating step 3

Step 3
Use a pair of tweezers to pull the vertical sync ribbon cable out of its socket on the LED driver board near the top left corner of your iMac. On some iMacs this may not be a ribbon cable but four separate, very fine and very fragile wires. Be very careful, if the tweezers slip off the plug, you will very likely pull a wire out of the assembly.

  • Use a pair of tweezers to pull the vertical sync ribbon cable out of its socket on the LED driver board near the top left corner of your iMac.

  • On some iMacs this may not be a ribbon cable but four separate, very fine and very fragile wires. Be very careful, if the tweezers slip off the plug, you will very likely pull a wire out of the assembly.

iMac の左上の隅近くにLEDドライバボードから接続されている、垂直同期信号用のリボンケーブルがあります。リボンケーブルをピンセットでつまんで慎重にソケットから引き抜きます。

一部のiMacではリボンケーブルではなく4本の独立した細くてとても壊れやすいワイヤになっています。 ピンセットがプラグから外れた場合は、アセンブリからワイヤを引き抜く可能性が非常に高いため注意してください。

Your contributions are licensed under the open source Creative Commons license.