Skip to main content

Fix Your Stuff

Right to Repair

Parts & Tools

Notice: You are editing a prerequisite guide. Any changes you make will affect all 15 guides that include this step.

English
French

Translating step 3

Step 3
Use a pair of tweezers to pull the vertical sync ribbon cable out of its socket on the LED driver board near the top left corner of your iMac. On some iMacs this may not be a ribbon cable but four separate, very fine and very fragile wires. Be very careful, if the tweezers slip off the plug, you will very likely pull a wire out of the assembly.
  • Use a pair of tweezers to pull the vertical sync ribbon cable out of its socket on the LED driver board near the top left corner of your iMac.

  • On some iMacs this may not be a ribbon cable but four separate, very fine and very fragile wires. Be very careful, if the tweezers slip off the plug, you will very likely pull a wire out of the assembly.

À l'aide d'une pince, retirez le câble de synchronisation verticale de son emplacement sur la carte de rétro-éclairage, près de l'angle supérieur gauche de l'iMac.

Sur certains iMac, vous ne trouverez pas de câble ruban, mais quatre petit fils très fragiles. Lorsque vous vous servez de la pince, faites attention de ne pas déchirer l'un des fils.

Your contributions are licensed under the open source Creative Commons license.