Describe the specific part or component of this device you're working on. Ex: Battery
Create a title.
Communicate background information before the reader dives into the guide.
Step 1 — Unscrew the cover
Remove the 4 Torx screws.
Step 2 — Removing the circuit board
Unclip the potentiometer. Do not change the position. That way the rotary switch will fit again during assembly.
Step 3 — Cable reel
If the cable is not wound up cleanly, it can be helpful to unwind the cable completely. To do this, remove the drum. Then rewind the flat cable without twisting.
Step 4 — Rotary switch
Rotary switch For the reassembly it may be necessary to remove the blue rotary switch beforehand. Put it back on the potentiometer only after the housing cover has been mounted.
Your contributions are licensed under the open source Creative Commons license.