BOSCH MFQ3530 450W Mixer power cable removal/repair

Step 1

Unscrew the two Torx T10 screws at the front on the bottom side. Then pull the entire gray plastic cover down towards the front. Caution: the sliding cover on the back is still attached.

Step 2

There is a catch on the inside under the area marked in red. Slide a small flat-blade screwdriver under the tab on the catch from the inside and lift it slightly. You can then pull the two housing parts a bit apart. Try to enlarge the gap along those housing parts.

Step 3

The most difficult hook is in front of the circuit board, directly under the gray rubberized handle. You can get it open by folding the device apart like a clam with force.

Step 4

The picture shows how to insert the white plastic ribbon. At the rear end, it is anchored to the slider for the blender jug. At the front end, it can engage in the round gray plastic part of the speed regulator. This is It is intended to ensure that the hand blender can only be switched on in position M.