Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 16 guides that include this step.

English
German

Translating step 22

Step 22
Be very careful not to touch the capacitor leads or any exposed solder joints on the back of the power supply (boxed in red). Grasp the small tab at the end of one of the bottom edge display adhesive strips and pull the adhesive toward the top of the iMac to remove it. Repeat this step with the other adhesive strip and remove it.
  • Be very careful not to touch the capacitor leads or any exposed solder joints on the back of the power supply (boxed in red).

  • Grasp the small tab at the end of one of the bottom edge display adhesive strips and pull the adhesive toward the top of the iMac to remove it.

  • Repeat this step with the other adhesive strip and remove it.

  • If either adhesive strip breaks before it's removed, use a plastic card to slice through the remaining adhesive.

Berühre keinesfalls die Leitungen oder Lötstellen der Kondensatoren auf der Rückseite des Netzteils. (rot markiert)

Fasse die kleine Lasche am Ende einer der Klebestreifen an der Unterkante des Displays, ziehe sie zur Oberkante des iMacs hin und entferne sie.

Wiederhole das Ganze für den anderen Klebestreifen.

Wenn einer der beiden Klebestreifen abreißt, bevor er ganz entfernt werden kann, dann trenne den restlichen Kleber mit einer Plastikkarte auf

Your contributions are licensed under the open source Creative Commons license.