Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 3 guides that include this step.

English
German

Translating step 1

Step 1
Remove the power supply cable from its connector by pulling it parallel to the logic board. During reassembly of the logic board, pay attention to the position of the I/O connectors. When the board is back in the case, insert a USB or Thunderbolt cable into one of the connectors to align it perfectly.
  • Remove the power supply cable from its connector by pulling it parallel to the logic board.

  • During reassembly of the logic board, pay attention to the position of the I/O connectors. When the board is back in the case, insert a USB or Thunderbolt cable into one of the connectors to align it perfectly.

Löse den Verbinder der Stromversorgungskabels, indem du ihn parallel zur Oberfläche des Logic Board heraus ziehst.

[* black] Remove the power supply cable from its connector by pulling it parallel to the logic board.
[* icon_reminder] During reassembly of the logic board, pay attention to the position of the I/O connectors. When the board is back in the case, insert a USB or Thunderbolt cable into one of the connectors to align it perfectly.

Your contributions are licensed under the open source Creative Commons license.