Skip to main content

Fix Your Stuff

Right to Repair

Store

Notice: You are editing a prerequisite guide. Any changes you make will affect all 9 guides that include this step.

English
Japanese

Translating step 1

Step 1
Remove the four 7.5 mm T8 screws from behind the GPU on the logic board. These screws are set inside large, spring-loaded Phillips #2 screws. To prevent the larger screws from spinning when you loosen the T8 screws, hold them with a fingertip or Phillips #2 screwdriver. These screws are set inside large, spring-loaded Phillips #2 screws. To prevent the larger screws from spinning when you loosen the T8 screws, hold them with a fingertip or Phillips #2 screwdriver.
  • Remove the four 7.5 mm T8 screws from behind the GPU on the logic board.

  • These screws are set inside large, spring-loaded Phillips #2 screws. To prevent the larger screws from spinning when you loosen the T8 screws, hold them with a fingertip or Phillips #2 screwdriver.

ロジックボード上のGPUの後ろから4本の7.5mm T8ネジを外します。

これらのネジは、大きなスプリング付きのPhillips#2ネジの中にセットされています。 T8ネジを緩めたときに大きなネジが回転しないようにするには、指先またはPhillips#2ドライバーで持ちます。

Your contributions are licensed under the open source Creative Commons license.