Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 27 guides that include this step.

English
Japanese

Translating step 3

Step 3
The following connector has an especially deep socket. Use care when disconnecting it. While gently pulling the I/O board cable upward near its connection to the logic board, use the flat end of a spudger to pry up on alternating sides of the connector to help "walk" it out of its socket.
  • The following connector has an especially deep socket. Use care when disconnecting it.

  • While gently pulling the I/O board cable upward near its connection to the logic board, use the flat end of a spudger to pry up on alternating sides of the connector to help "walk" it out of its socket.

  • Remove the I/O board cable.

次のコネクターのソケットは特に深くなっています。このソケットから接続を外す際はご注意ください。

スパッジャーの平面側先端を使って、I / Oボードのケーブルをロジックボードの接続部付近に向けてゆっくりと跳ね上げます。コネクタの両側から上向きに押し上げて、ソケットから外します。

I/O ボードケーブルを取り出します。

Your contributions are licensed under the open source Creative Commons license.