Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 16 guides that include this step.

English
Spanish

Translating step 7

Step 7
Remove the front panel assembly. Use an opening pick to cut away any residual adhesive that may still be connecting the front panel assembly to the frame. If you experience "ghost" or "phantom" touch input issues with your new display, this can be resolved by adding a layer of very thin insulating tape, such as Kapton (polyimide)  tape, to the highlighted areas on the back of the panel. iFixit replacement digitizers come with the proper insulation and should not require the addition of any tape.
Remove the front panel assembly
  • Remove the front panel assembly.

  • Use an opening pick to cut away any residual adhesive that may still be connecting the front panel assembly to the frame.

  • If you experience "ghost" or "phantom" touch input issues with your new display, this can be resolved by adding a layer of very thin insulating tape, such as Kapton (polyimide) tape, to the highlighted areas on the back of the panel. iFixit replacement digitizers come with the proper insulation and should not require the addition of any tape.

  • Without the proper insulation, these areas of the digitizer can ground out against other components, causing touch input malfunction.

  • The insulation is not visible to the naked eye, and is different from the foam dust barrier strips found on many iPads.

  • During reassembly, before installing a display, remove any remaining adhesive from the iPad, and clean the glued areas with high concentration isopropyl alcohol (90% or greater) and a lint-free cloth. This helps prep the iPad for fresh adhesive and ensures that it will bond properly.

  • Test your iPad's functions and install pre-cut adhesive strips to the back of the display using our display adhesive application guide before sealing it up.

Remueve el ensamble del panel frontal.

Usa una púa de apertura para cortar cualquier adhesivo residual que puede estar conectando el ensamble del panel frontal al marco.

Si estás experimentando problemas "fantasma" con la entrada de touch en tu nueva pantalla, esto puede ser resuelto añadiendo una capa de cinta aislante muy fina, como cinta Kapton (poliamida), en las áreas destacadas en la parte de atrás del panel. Los digitalizadores de remplazo de iFixit vienen con aislamiento apropiado y no deberían requerir la adición de cinta.

Sin aislamiento apropiado, estas áreas del digitalizador pueden conectarse a tierra con otros componentes, causando el mal funcionamiento de la entrada de touch.

El aislamiento no es visible a simple vista, y es diferente a las tiras de protección contra polvo de espuma encontrados en muchos iPads.

Durante el re-ensamble, antes de instalar la pantalla, remueve todo adhesivo restante del iPad, y limpia las áreas pegadas con alcohol isopropilico de alta concentración (90% o mayor) y una tela libre de pelusa. Esto ayuda preparar el iPad para el adhesivo fresco y asegura que se uniera apropiadamente.

Prueba las funciones de tu iPad e instala tiras adhesivas pre-cortadas a la parte de atrás de tu pantalla usando nuestra guía de aplicación de adhesivo para pantallas antes de sellarlo.

Your contributions are licensed under the open source Creative Commons license.